2007 Yamaha Outboard 50 Boat Motor Owners Manual

Operation
gine  shut-off switch,  then turning  the  main
switch to
(off).
EMU27862
Trimming outboard motor
EWM00740
WARNING
Excessive  trim for  the  operating  condi-
tions  (either trim  up  or  trim down)  can
cause   boat  instability   and   can   make
steering the  boat more  difficult. This  in-
creases the  possibility of an  accident. If
the boat begins to feel unstable or is hard
to steer,  slow  down and/or  readjust the
trim angle.
2.
After  stopping  the  engine,  disconnect
the fuel line if there is  a fuel joint on the
outboard motor.
The trim  angle of the  outboard motor helps
determine the position of the bow of the boat
in the water. Correct  trim angle will help im-
prove performance and  fuel economy while
reducing strain  on the  engine. Correct  trim
angle  depends   upon  the   combination  of
boat, engine,  and propeller.  Correct trim  is
also affected by variables such as the load in
the boat, sea conditions, and running speed.
ZMU03108
3.
Tighten  the air  vent screw  on  the fuel
tank cap (if equipped).
ZMU02301
4.
Remove the  key if  the boat  will be  left
unattended.
TIP:
The engine  can also  be stopped by  pulling
the cord and  removing the clip from the  en-
48
Product Specification
CategoriesMarine, Yamaha Outboard Manuals
Document TypeBoat Motor Manual Free Download. Marine Operator's Boating Guide.
Tags
Model Year2007
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 90 pages
LanguageEnglish
Product BrandYamaha Motor. Yamaha Motor Corporation, USA - Support Customer Relations for US: 1-800-962-7926
Yamaha Boats: 1-800-962-7926
Yamaha Outboard Customer Relations: 1-866-894-1626 , Yamaha Outboard
Document File TypePDF
Publisheryamaha-motor.com
Wikipedia's PageYamaha Motor Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website