OVER-REVOLUTION LIMITING SYSTEM
If the engine overheats, the S.L.O.W. (Speed Limit-
ing Overheat Warning) protection system will im-
mediately limit the engine speed to 2000 RPM. If
the engine was running faster than 2000 RPM
when the S.L.O.W. system activated, it will shake
noticeably.
This system is activated when engine speed ex-
ceeds maximum recommended speed for more
than 10 seconds.
If this system activates, engine speed will automat-
ically be reduced to approximately 3000 RPM.
To RESET the S.L.O.W. protection system, the en-
gine must be shut OFF and the cooling temperature
restored.
This system must be reset by moving the throttle to
the idle position for about one second to restore full
engine operation.
IF the S.L.O.W. protection system activates and the
stream from the water pump indicator becomes in-
termittent or stops, reduce speed to idle and:
IMPORTANT: The Over-Revolution Limiting Sys-
tem will not be activated at recommended maxi- • Shift to NEUTRAL;
mum throttle unless propeller pitch is insufficient or
other factors (like “over-trimming” or “ventilation”)
prevail.
•
•
•
SHUT OFF the engine;
Tilt the motor up;
Clean the intake screens and four small gearcase
holes of any blockage;
If the system activates for no apparent reason, see
your Dealer.
•
•
•
Clean the water pump indicator of any blockage;
Lower the motor; and
Restart the engine and run at idle.
ENGINE OVERHEATING
IF cleaning the screens and indicator does not re-
store the water pump indicator’s steady discharge,
SHUT OFF the engine and do not attempt to oper-
ate it. See your Dealer.
IMPORTANT: Do not run your engine — even for a
brief start-up — without supplying water to it. Refer
to Flushing.
While boating, the engine’s water intake must stay
completely submerged and unobstructed. Observe
proper transom height and trim angle. While the en-
gine is running, the engine’s water pump indicator
must discharge a steady stream of water. Check
IF cleaning the screens and indicator does restore
the water pump indicator’s steady discharge, you
might have to run for two minutes in NEUTRAL to
allow the engine to cool.
the indicator often, especially when operating in IMPORTANT: You must restore cooling to the en-
weeds, muddy and debris-laden water, at extreme
trim angles, or in shallow water drive (if equipped).
gine to avoid serious engine damage.
After any overheat, have your Dealer:
Torque the cylinder head screws.
Inspect the water pump for excessive wear or dam-
age.
Inspect the thermostats.
Inspect the engine for leaks.
1
1.
Water pump indicator
Operation - 29
| Categories | BRP Brand Manuals, Johnson 4-Stroke Manuals, Johnson Brand Manuals, Johnson Outboard Manuals |
|---|---|
| Tags | Johnson 25 hp, Johnson E4, Johnson EL4 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 3 out of 4)
Marine readers have rated 2007 Johnson 25 hp E4 EL4 4-Stroke Outboard Owners Manual 3.0 out of 4.0 based on 2 product reviews. I would rather you had just asked for a few bucks. This is so annoying. Kick backs and rejecting.
very good, I need manual 1967 Jhonson 55 tanks