Maintenance
gine will be damaged from overheating.
Before starting the engine, be sure to
supply water to the cooling water passag-
es.
EMU28400
Lubrication (except oil injection
models)
1.
Grease the spark plug threads and in-
stall the spark plug(s) and torque to
proper specification. For information on
spark plug installation, see page 53.
Change the gear oil. For instructions,
see page 60. Inspect the oil for the pres-
ence of water that indicates a leaky seal.
Seal replacement should be performed
by an authorized Yamaha dealer prior to
use.
ECM00290
CAUTION:
If the fresh water level is below the level
of the anti-cavitation plate, or if the water
supply is insufficient, engine seizure may
occur.
2.
6.
Cooling system flushing is essential to
prevent the cooling system from clog-
ging up with salt, sand, or dirt. In addi-
tion, fogging of the engine is mandatory
to prevent excessive engine damage
due to rust. Perform the flushing and
fogging at the same time.
3.
Grease all grease fittings. For further de-
tails, see page 53.
EMU28421
Cleaning and anticorrosion
measures
1.
2.
3.
Wash down the exterior of the outboard
motor with fresh water and dry off com-
pletely.
EWM00090
WARNING
q
q
Do not touch or remove electrical parts
when starting or during operation.
Keep hands, hair, and clothes away
from the flywheel and other rotating
parts while the engine is running.
Spray the outboard motor exterior with
“
Yamaha Silicone Protectant” (Part No.
LUB-SILCNE-13-00).
Wax the cowling with a non-abrasive
wax such as “Yamaha Silicone Wax”
(Part No. ACC-11000-15-02).
7.
8.
Run the engine at a fast idle for 10–15
minutes in neutral position.
Just prior to turning off the engine, quick- Battery care
EMU28430
ly spray “Yamaha Stor-Rite Engine
Fogging Oil” (Part No. LUB-STRRT-12-
EWM00330
WARNING
00)
alternately into each carburetor or
Battery electrolytic fluid is dangerous; it
contains sulfuric acid and therefore is
poisonous and highly caustic.
Always follow these preventive mea-
sures:
the fogging hole of the silencer cover, if
equipped. When properly done, the en-
gine will smoke excessively and almost
stall.
9.
Remove the outboard motor from the
test tank.
Drain the cooling water completely out
of the motor. Clean the body thoroughly.
Install the silencer cover/cap and top
cowling.
q
Avoid bodily contact with electrolytic
fluid as it can cause severe burns or
permanent eye injury.
10.
11.
q
Wear protective eye gear when han-
48
| Categories | Yamaha Outboard Manuals |
|---|---|
| Document Type | Boat Motor Manual Free Download. Marine Operator's Boating Guide. |
| Tags | Yamaha F30D, Yamaha F40D |
| Model Year | 2005 |
| Download File |
|
| Language | English |
| Product Brand | Yamaha Motor. Yamaha Motor Corporation, USA - Support Customer Relations for US: 1-800-962-7926
Yamaha Boats: 1-800-962-7926 Yamaha Outboard Customer Relations: 1-866-894-1626 , Yamaha Outboard |
| Document File Type | |
| Publisher | yamaha-motor.com |
| Wikipedia's Page | Yamaha Motor Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)