5)
6)
Start the engine — run it at idle only and
flush it for at least five minutes. Check the
water pump indicator. A steady stream of wa-
ter must flow. If it does not, shut OFF the en-
gine and investigate. Refer to Engine
Overheating.
1
Leave the outboard in vertical position long
enough to completely drain the powerhead.
ENGINE OVERHEATING
IMPORTANT: Do not run your engine — even for a
brief start-up — without supplying water to it. Refer
to Flushing.
While boating, the engine’s water intakes must stay
completely submerged and unobstructed. Observe
proper transom height and trim angle. While the en-
gine is running, the engine’s water pump indicator
must discharge a steady stream of water. Check
the indicator often, especially when operating in
weeds, muddy and debris-laden water, and at ex-
treme trim angles.
1. Water pump indicator
If the stream of water from the water pump indicator
becomes intermittent or stops, reduce speed to idle
and:
•
•
•
•
Shift to NEUTRAL;
SHUT OFF the engine;
Tilt the motor up;
Clean the water intakes and the water pump indi-
cator;
•
•
Lower the motor; and
Restart engine and run at idle.
If cleaning the screens and indicator does not re-
store the water pump indicator’s steady discharge,
SHUT OFF the motor and do not attempt to operate
it. See your Dealer.
1
If you succeed in restoring the water pump indica-
tor’s steady discharge, continue to IDLE the engine
until it cools.
After an engine overheat, have your Dealer torque
the cylinder head and exhaust cover screws and
DETERMINE THE CAUSE OF THE OVERHEAT.
1.
Water intakes
Operation - 25
| Categories | BRP Brand Manuals, Johnson 2-Stroke Manuals, Johnson Brand Manuals, Johnson Outboard Manuals |
|---|---|
| Tags | Johnson 55 hp |
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)