FUEL PUMP FILTER
FUSES
The fuel filter is located in the motor’s fuel pump. An
authorized Evinrude/Johnson DEALER should ser-
vice the fuel filter.
IMPORTANT: Always carry spare fuses.
The fuse is located in the fuse holder. Refer to En-
gine Specifications.
WARNING
Prevent excessive fuel spillage by discon-
necting fuel hose from motor before disas-
sembly.
The filter is located under the inlet cover on the fuel
pump. To service, proceed as follows:
If portable tank is used, disconnect the fuel hose
from the motor before servicing the filter.
Loosen screw and remove the cover. Do not lose
O-rings.
Fuse Failure
A minor electrical problem can blow a fuse. Re-
place it with a fuse of the same rating.
Repeated failures of fuses in the same position in-
dicate a serious problem. Do not replace it with
higher rated fuses; see your DEALER for service.
3
2
1
1.
2.
3.
Cover
Filter
O-rings
Wash filter with clean solvent; blow dry.
Reinstall filter, keeping lip of filter screen toward
fuel pump body.
Install large O-ring in its groove in the cover and the
small O-ring around center post of pump body.
Replace O-rings if cut or damaged.
Reinstall cover.
Tighten cover screw securely; clean up spilled fuel.
Check for leaks – connect fuel hose to motor and
squeeze primer bulb until firm.
WARNING
Failure to inspect your work could allow fuel
leakage to go undetected, becoming a fire
or explosion hazard.
38
- Maintenance
| Categories | BRP Brand Manuals, Johnson 2-Stroke Manuals, Johnson Brand Manuals, Johnson Outboard Manuals |
|---|---|
| Document Type | Boat Motor Manual. Marine Operator's Engine Guide. |
| Tags | Johnson 25 hp, Johnson 30 hp, Johnson E, Johnson EL |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Publisher | johnson.com |
| Wikipedia's Page | Johnson Outboards |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)