Using Your E-TEC Outboard
Starting
After Engine Starts
Turn the key switch fully clockwise to the Check the water pump indicator. A steady
START position.
stream of water indicates the water pump is
working. If a steady stream of water from the
NOTICE
aged if operated continuously for more engine. Refer to Engine Overheating on
The starter motor can be dam- water pump indicator is not visible, stop the
than 20 seconds.
page 38.
Upon start-up, release the key.
Engine Stopping
If the engine did not start, release the key mo-
mentarily, then try again.
Move control handle to NEUTRAL.
Turn key switch counterclockwise to the OFF
position.
Each time the key switch is turned from OFF
to ON, the warning system will self-test. Refer
to Routine Inspection Checklist on page
39.
If the warning system fails to self-test dur-
OFF
ing start-up, see your Dealer.
1
ON
If your outboard does not react normally to
this starting procedure or if it fails to start, re-
fer to Troubleshooting on page 50.
KEY
START
007072
1.
Key switch, OFF position
Remove the key when the boat will be unat-
tended. If equipped, close the vent screw on
the fuel tank’s filler cap.
22
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Document Type | Boat Motor Manual. Marine Operator's Engine Guide. |
| Tags | Evinrude 75 hp, Evinrude 90 hp, Evinrude PL, Evinrude PX, Evinrude SL, Evinrude WDEL, Evinrude WDEX, Evinrude WEL, Evinrude WEX |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Publisher | evinrude.com |
| Wikipedia's Page | Evinrude Outboard Motors |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)