required.by.the.indications.on.the.dip.sticks...
Refer to Table 1: “SAE Viscosity Chart” and your
engine.manual.included.in.the.owner’s.packet..
Follow.engine.manufacturer’s.recommendations..
2.. Move.the.throttle.control(s).to.the.idle.position.
(lever(s).is.all.the.way.rearward).
3... Turn.the.key.switch.to.start.position.and.hold.until.
engine.starts,.but.for.no.longer.than.10.seconds..If.
engine.does.not.start,.let.go.momentarily,.then.try.
again.
.
DO.NOT.USE.MULTIGRADE.OIL..Power.steering.
and power trim use automatic transmission fluid.
Check the fluid levels in the vertical drive units or
transmission.as.often.as.practical.
4... As.soon.as.engine.starts,.release.key.to.ON.or.
RUN.
THE FOLLOWING
IFTHELOWEST
SAEVISCOSITY
ANTICIPATED
NOTICE
OILSARE
TEMPERATUREIS*
RECOMMENDED
Priming is not necessary for EFI engines. Re-
fer to the engine owner’s manual for additional
information.
3
2
O
F(0
F(-18 C)to32
Below0 F(-18
o
C)andabove
F(0 C)
C)
SAE30
SAE20W-20
SAE10W
0
O
O
O
O
O
O
*Temperaturerangeyouexpecttooperate.
Note: Useonly singleviscosity oils.
C. Shifting and Control Speed
.
1..
Move.shifter.control(s).to.the.neutral.detent.(idle).
position..This.will.engage.neutral.start.switch.and.
allow.engine.to.start..Move.the.throttle.control(s).
to.the.idle.position.
Table 1: SAE Viscosity Chart
3..
Start.and.operate.the.bilge.blower.system.for.at.
least.four.(4).minutes.before.start-up.
.
4..
Lower.the.vertical.outdrive.units.using.trim.
switch(s).making.sure.the.water.intakes.are.under.
the.water.
DO NOT shift into FORWARD or REVERSE
unless engine is running. Damage to the shift
system could result from trying to shift without
the engine running. Carefully check function of
all control and engine systems before leaving
the dock.
B. Cold / Warm Engine Start (EFI Engines)
1...
Moving.the.black.gaffrig.shifter.control(s),.Figure.
A1,.to.the.center.or.straight.up.position.places.
the.engine(s).in.neutral..Notice.as.you.push.the.
shifter.control(s).to.the.neutral.position.you.will.
feel.the.neutral.detent.engage.thus.indicating.you.
are in neutral. Note: A “start-in-neutral-only” fea-
ture.prevents.starting.the.engine(s).while.in.gear.
2..
3..
To.go.FORWARD.-.move.the.shifter.control.for-
ward..
To.go.in.REVERSE.-.move.the.shifter.control.rear-
ward..
Trim Switches Throttle Controls
Shifter Controls
NOTICE
DO NOT shift from forward to reverse when
the boat is planing.
NOTICE
DO NOT shift if engine speed is over 00 rpm.
4..
To.go.from.FORWARD.to.REVERSE,.or..
REVERSE.to.FORWARD;.always.pause.at.NEU-
TRAL.and.allow.engine.speed.to.return.to.idle.
Figure A1: Gaffrig Shifter and Throttle Controls
(Twin Controls Shown)
Operation - Section A
Owner’s Manual Page
| Categories | Four Winns Manuals, Four Winns Vista Manuals, Outboard Marine Corporation Manuals |
|---|---|
| Tags | Four Winns Horizon 310 |
| Model Year | 2007, 2008 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Boats and Cruisers, Four Winns. For support contact your dealer at http://www.fourwinns.com/locate-dealer.aspx |
| Document File Type | |
| Publisher | fourwinns.com |
| Wikipedia's Page | Outboard Marine Corporation |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)