Product Information
INSTALLING THE OUTBOARD
Install the mounting bolts through the stern
brackets and transom. Install round backing
plates and locknuts onto bolts and tighten se-
curely.
WARNING
The outboard must be correctly
installed. Failure to correctly install
the outboard could result in serious
injury, death or property damage.
2
1
2
IMPORTANT: The outboard warranty will not
cover product damage or failure that results
from incorrect outboard installation.
WARNING
Even if equipped with clamp screws,
the outboard must be bolted to the
boat to prevent it from “working off
the transom” during operation.
3
1.
2.
3.
Transom plate
Small washers
Large washers
Use Transom Mounting Kit, P/N 394219, to
prevent loss of outboard. The kit includes a
transom mounting plate and hardware for fas-
tening outboard to transom.
The kit also includes clamp pads, which must
be used to secure mounting bolts in slots at
the bottom of the outboard stern brackets.
Center the outboard on the transom (or
mounting bracket) and tighten clamp screws
by hand.
Use the outboard stern brackets as a tem-
plate for location and size of holes to drill in
the transom.
Use each stern bracket’s mounting holes as a
guide to drill four 11/32 in. (8.7 mm) holes
through the transom.
1
1.
Clamp pad
1
1
1
1
1.
Drilled transom holes
40
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude MFE Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 55 hp, Evinrude MJRL, Evinrude MRL |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)