Maintenance
STORAGE
FLUSHING
If desired, the outboard can be flushed after
each use on a trailer or at dockside while it is
vertical.
DANGER
DO NOT run the engine indoors or with-
adequate ventilation or permit
exhaust fumes to accumulate in con-
fined areas. Engine exhaust contains
carbon monoxide which, if inhaled, can
cause serious brain damage or death.
out
1)
Place the outboard in an area with good
drainage.
2)
3)
Connect garden hose to flushing port.
Turn on the water. It is not necessary to
run the engine for a good flushing.
You must protect against natural environmen-
tal conditions that can be damaging to an out-
board. Temperature and humidity changes
while your outboard is not in use can cause
corrosion of internal engine parts when they
are not protected. Fuel remaining in your fuel
tank can oxidize which can result in loss of oc-
tane and can cause gum deposits in the fuel
system. Your warranty does not cover engine
failure caused by these conditions.
WARNING
Prevent injury from moving engine
components. Before starting the out-
board:
IMPORTANT: The “CHECK ENGINE” or
“CHK ENG” System Check gauge light may il-
luminate if you are running the outboard dur-
ing the flushing procedure. This is normal.
The outboard will continue to run as long as it
is being supplied with water.
•
•
Shift it to NEUTRAL.
Keep hands, clothes, and hair clear of
powerhead.
Remove the propeller.
4)
Leave the outboard in vertical position long
enough to completely drain the power-
head.
•
Store fuel tanks in a well-ventilated
area, away from heat and open flame.
Prevent escape of liquid or vapors
which could accidentally ignite:
IMPORTANT: If you cannot store the out-
board in the recommended vertical position,
be sure the cooling system is drained com-
pletely. Never place the gearcase higher than
the powerhead. Any water remaining in the
exhaust passages can run into the cylinders
and cause serious damage.
Close the filler cap vent screw, if
equipped.
Be sure the disconnected fuel hose
does not drip.
SHORT-TERM (BETWEEN USES)
If you must tilt the outboard to remove it from
the water, lower it and allow the cooling sys-
tem to drain completely as soon as you clear
the launch area.
Between uses, store your outboard in a verti-
cal position.
34
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 75 hp, Evinrude 90 hp, Evinrude PL, Evinrude PX, Evinrude SL |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)