2004 Evinrude 75 90 hp E-TEC PL PX SL Outboard Motor Owners Manual

OPERATION
HIGH ALTITUDE
UNDER TOW
Your outboard’s EMM will automatically com-    Should you require a tow from another boat:
pensate for  changes in  altitude. However,  if
Shift your engine to NEUTRAL;
Tilt its gearcase out of the water;
Off-load all persons into another boat; and
Keep speed slower than planing speed.
you boat above 3000 ft. (900  m), you will ex-
perience a slight loss of power due to reduced
air density.
If your engine drops below the recommended
RPM operating range at full throttle, have your
Dealer select a lower pitch propeller.
FUSE
If you return to sea level, have your Dealer in-
stall the  original  propeller and  verify correct
RPM operating range.
A  blown  fuse  will  not  allow the  engine  to
crank. Replace it with a fuse of the same rat-
ing. A spare fuse is provided.
Repeated fuse  failures indicate a potentially
serious problem. Do not replace it with higher
rated fuse; see your Dealer for service.
FREEZING WEATHER
IMPORTANT: Use Evinrude/Johnson XD100
oil when operating your Evinrude E-TEC out-
board in  freezing  weather. Refer  to Oil  Re-
quirements on page 16.
Fuse Replacement
During  operation in  freezing  weather,  keep
the gearcase submerged at all times.
Upon removing your outboard from the water,   amp fuses.
leave it  in a  vertical position until  its cooling
system is drained.
IMPORTANT: Use only fuses of the same rat-
ing. Your Evinrude E-TEC outboard uses 10-
Remove  engine cover.  Install spare  fuse  in
place of failed fuse.
IMPORTANT:  Store the  outboard vertically.
Water remaining in the gearcase, cooling sys-
tem or other components can freeze, causing
serious engine damage.
IMPORTANT: If your  outboard’s gearcase is
equipped with an  integral speedometer pick-
up, all water must be cleared from the hose to
prevent gearcase damage. Refer  to Storage
on page 34.
1
SHALLOW WATER
IMPORTANT: Gearcase damage can occur if
the gearcase is allowed to drag on the water-
way bottom.
2
1.
2.
Fuse
Spare fuse
IMPORTANT: Failure to install cover securely
may cause electrical problems.
DUAL OUTBOARD OPERATION
When in reverse  above slow speed, be  sure
both outboards are running,  even if one is  in
NEUTRAL.
If it is  necessary to return to harbor  with one
outboard not running,  tilt the inoperative out-
board high enough to keep its propeller out of
the water.
29
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual
Tags, , , ,
Model Year2004
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 60 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website